BCSFJ - M & T GLOSS WHITE PAINT 7172

Product Identification

Product ID:M & T GLOSS WHITE PAINT 7172
MSDS Date:11/12/1985
FSC:8010
NIIN:00N009346
MSDS Number: BCSFJ

Responsible Party
CROWN INDUSTRIAL PRODUCTS,CO., INC.
STATE LINE ROAD
HEBRON, IL 60034

Emergency Phone: 815-648-2424

Info Phone: 815-648-2424

Preparer: ROBERT E. BAYTON

Cage: 92381

Contractor
CROWN INDUSTRIAL PRODUCTS CO
350 HEBRON, IL 60034 US

Telephone: 815-648-2424

Cage: 92381

Ingredients

XYLENES (O-,M-,P- ISOMERS) (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 1-10%

OSHA PEL 100 PPM/150 STEL

ACGIH TLV: 100 PPM/150STEL;9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


NAPHTA (PETROLEUM SPIRITS OR BENZIN)

CAS: 8030-30-6

RTECS: DE3030000

Fraction By Weight: 1-10%

OSHA PEL 100 PPM


NAPHTHA (PETROLEUM SPIRITS OR BENZIN)

CAS: 8030-30-6

RTECS: SE7555000

Fraction By Weight: 1-10%

OSHA PEL 100 PPM


TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 1-10%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


METHYLENE CHLORIDE (SARA III)

CAS: 75-09-2

RTECS: PA8050000

Fraction By Weight: 31-50%

OSHA PEL 500 PPM/C,1000; Z2

ACGIH TLV: 50 PPM, A2; 9192

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


LIQUIFIED PETROLEUM GAS,SWEETENED

CAS: 68476-86-8

Fraction By Weight: 11-30%

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALE:VAPORS CAN CAUSE
HEADACHE,DIZZINESS,NAUSEA, & VOMITING,MAY CAUSE CHEMICAL PNEUMONIA
IF ASPIRATED INTO LUNGS.EYE:MAY CAUSE IRRITATION,CORNEAL
INJURY.SKIN:PROLONGED CONTACT CAN CAUSE IRRITATION & POSSIBLE
DERMATITIS.METHYLENE CHLORIDEIS RAPIDLY ABSORBED THROUGH THE SKIN.
Explanation of Carcinogenicity:NA
Effects of Overexposure:SEE MED CONDITIONS AGGRAVATED BY OVEREXPOSURE.
Medical Cond Aggravated by Exposure:MAY CAUSE MYOCARDIAL
IRRITABILITY,AVOID EPINEPHRINE OR SIMILAR DRUGS IF AT ALL POSSIBLE.

First Aid

First Aid:EYES:FLUSH WITH WATER FOR 15 MIN,GET MEDICAL
ATTENTION.SKIN:REMOVE CONTAMINATED CLOTHING,WASH SKIN WITH SOAP AND
WATER.INHALE:REMOVE FROM EXPOSURE,SUPPORT BREATHING,BEGIN
ARTIFICIAL RESPIRATION,ADMINI STER O*2.INGEST:DRINK LARGE AMOUNTS
OF WATER.DO NOT INDUCE VOMITING.

Fire Fighting

Flash Point Method:TCC
Flash Point:<20F/<-6.6C
Lower Limits:1.8
Upper Limits:9.5
Extinguishing Media:CO*2,DRY CHEMICAL,FOAM
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT
Unusual Fire/Explosion Hazard:TREAT AS CYLINDERS OF COMPRESSED GAS

Accidental Release

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION.AVOID BREATHING
VAPORS.CLEAN UP WITH INERT MATERIALS.DISPOSE OF IAW ALL
LOCAL,STATE,AND FEDERAL REGULATIONS.
Neutralizing Agent:NONE LISTED BY MFG

Handling

Handling and Storage Precautions:DO NOT STORE IN DIRECT SUNLIGHT,NEAR
OPEN FLAMES OR RADIATORS OR AT TEMP.EXCEEDING
120F/48.8C.CONCENTRATING VAPORS AND INHALING CONT.MAY BE FATAL.

Exposure Controls

Respiratory Protection:RESPIRATORY PROTECTION SHOULD BE IAW 29CFR
1910.34.(MFG)NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR AREA OF
CONCEN
Ventilation:LOCAL EXHAUST IS ADEQUATE (MFG)
Protective Gloves:POLYETHYLENE OR NEOPRENE
Eye Protection:SAFETY GLASSES ARE RECOMMENDED
Other Protective Equipment:PROTECTIVE CLOTHING AND EQUIPMENT:SEE 29CFR
1910.132 &133
Work Hygienic Practices:WASH EXPOSED SKIN WITH SOAP AND WATER.
Supplemental Safety and Health
MFG STATES THAT CAS#8030-30-6 IS CORRECT FOR INGREDIENTS 2&3.

Chemical Properties

Boiling Pt:B.P. Text:NA
Vapor Pres:45-50 PSIG
Spec Gravity:>1
Evaporation Rate & Reference:<1,(ETHER=1)
Solubility in Water:NEG
Appearance and Odor:WHITE/CHLORINATED ODOR
Percent Volatiles by Volume:>85

Stability

Stability Indicator/Materials to Avoid:YES
ALKALI METALS,MINERAL ACIDS
Stability Condition to Avoid:OPEN FLAMES,SPARKS,ELECTRICAL SPARK
SOURCES
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD SMALL
AMOUNTS OF HALOGEN ACIDS, CO AND OTHER TOXIC CHEMICALS.
Conditions to Avoid Polymerization:WILL NOT OCCUR

Disposal

Waste Disposal Methods:AEROSOL CONTAINER:DO NOT PUNCTURE OR
INCINERATE.EMPTY CONTAINERS MAY BE DISPOSED OF THROUGH NORMAL
CHANNELS.FULL OR PARTIALLY FULL CONTAINERS

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.